Publicidad
Idiomas disponibles
Idiomas disponibles
9. Install the AC Single Supply
2-Pin Power
Connector
to control box
DC-DC Booster Assembly
IMPORTANT! Verify that you are following the correct power system installation
based on your model number. For a multi-output AC supply power unit installation,
refer to "Install AC Multi-Output Supply". For a hard wire power installation, refer to
"Hard Wire Installation".
IMPORTANT! Use care not to pinch the tube or cables when installing the cover.
IMPORTANT! The area in front of the sensor must be free of objects during the 2
minute learning cycle or the faucet may not function properly.
NOTE: When the faucet is initially connected to an AC or DC power source, the LED
will flash to indicate the sensor detection range is auto-adjusting.
Unthread the control box screws to remove the control box cover.
Connect the power cords.
Plug the AC supply into the wall outlet.
Secure any excess wire under the deck.
Kohler Co.
Power Cord
2-Pin Power
Molex Connector
to Battery/AC/Hybrid Battery
13
AC Supply
LED
1561536-2-A
Publicidad
