ASSEMBLY
NOTE: Assemble the trampoline on a soft and clean surface. If necessary, place a blanket
underneath so that the surface cannot be scratched or damaged.
Two people are needed for setup.
The fitness trampoline can be assembled with or without a grab handle as an option. (Assembly
steps 5 – 10 are omitted if the grab handle is not required).
1.
Place all the parts on the floor; connect the three parts of the frame (TR01) as shown.
2.
Place the bounce mat (TR03) on the floor with the hooks facing upwards. Place the frame
in the middle of the bounce mat. (Make sure that the brackets of the legs are also pointing
upwards).
Now connect the rubber cords (TR04) with the hooks of the bounce mat and the frame
using a loop.
Always switch to the opposite side.
15
www.DEUBAXXL.de