Publicidad
Idiomas disponibles
Idiomas disponibles
Insert the dowel
Using a crosshead screwdriver, screw the
screw
into the dowel.
26
Hang the weather station by placing the
hanger
23
External sensor
Mark the position of the hole (ø approx. 7 mm)
on the wall.
Drill the hole with an electric drill.
Insert the dowel
Using a crosshead screwdriver, screw the
screw
into the dowel.
31
Hang the external sensor by placing the
hanger
29
Note: Ensure that the external sensor does not
come into contact with water or direct sunlight.
Electronic devices may adversely affect the wire-
less signal reception.
Setting the language / time
zone / time / date manually
The reception of DCF radio signal where the
weather station has been positioned may become
degraded or interrupted. If this happens you can
set the device manually.
1. Press and hold down the CLOCK button
for about 3 seconds.
2. Press the SET / RESET button
tween the 12- and 24-hour clock display modes.
into the drilled hole.
27
on the screw.
into the drilled hole.
32
on the screw.
22
to switch be-
20
GB/MT
77
Publicidad
