Descargar Imprimir esta página

Husqvarna K1 PACE Manual Del Usuario página 15

Ocultar thumbs Ver también para K1 PACE:

Publicidad

Idiomas disponibles

Idiomas disponibles

The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
If you do not do maintenance, it decreases the
life cycle of the product and increases the risk of
accidents.
Cutting blades
WARNING:
gloves when you assemble the product.
WARNING:
and cause injury to the operator.
WARNING:
for cracks, lost segments distortion or
unbalance prior to use and immediately after
striking an unintended object. Do not use a
damaged cutting blade. After inspecting and
installing the cutting blade, position yourself
and bystanders away from the plane of the
rotating cutting blade and run the power tool
at maximum no load speed for one minute.
WARNING:
manufacturer gives warnings and
recommendations for the operation and
correct maintenance of the cutting blade.
Those warnings are supplied with the cutting
blade. Read and obey the instructions that
are supplied with the cutting blade.
Cutting blade vibration
CAUTION:
with too much force, the cutting blade
can become too hot, bend and cause
vibrations. Use the product with less force.
If the vibrations continue, replace the cutting
blade.
Applicable cutting blades
CAUTION:
recommended cutting blades for K1
PACE and the material to be cut. The
recommended cutting blades decrease the
risk of serious injury and increase the
1598 - 007 - 28.09.2023
Assembly
Always use protective
A cutting blade can break
Examine the cutting blade
The cutting blade
If you use the product
Use HUSQVARNA
Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
Only use original spare parts.
cutting and X-halt performance. If general
high speed cutting blades are used,
the performance and cutting quality will
decrease.
WARNING:
and abrasive blades for concrete and metal.
Do not use blades with serrations such
as circular wood cutting blades or blades
with carbide tips. The risk of kickback is
increased and carbide tips can come off and
be thrown at high speed. This can result in
injury or death.
WARNING:
for any other materials than what it was
intended to cut.
WARNING:
that comply with applicable national or
regional standards, for example EN12413,
ANSI B7.1. or EN13236.
WARNING:
with a rated speed value lower than that of
the product. The rated speed value of the
cutting blade is marked on the cutting blade
and that of the product is marked on the
type plate.
Only use diamond blades
Never use a cutting blade
Use only cutting blades
Do not use a cutting blade
100 m/s
XXXX rpm
15

Publicidad

loading

Este manual también es adecuado para:

K1 pace rescueK1 pace rail