Husqvarna K1 PACE Manual Del Usuario página 24

4. When all LEDs on the battery come on, the battery is
fully charged.
5. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
6. Remove the battery from the battery charger.
Note:
Refer to the battery and battery charger
manuals for more information.
Basic working techniques
WARNING:
cutter to the side. This can prevent the free
movement of the blade and cause the blade
to break, which can cause an injury.
WARNING:
blade. The blade can become damaged and
broken, which can cause an injury. Use only
the cutting edge.
WARNING:
blade to cut plastic material. The heat that
occurs can melt the plastic. Melted plastic
can attach to the cutting blade and cause a
kickback.
• The product is made for high speed diamond blades,
abrasive blades and recommended blades for the
product. Use HUSQVARNA recommended cutting
blades for the product.
• The product is made to cut into tiles, light concrete
and stone. Use only for this type of operation.
• Make sure that the cutting blade does not show
signs of damage and that it is attached correctly,
Abrasive blades on page 16 and To install
refer to
the cutting blade on page 19 .
• Always use the correct cutting blade for the type of
Cutting blades on page 15 .
operation, refer to
• Do not cut asbestos material.
• Always hold the power cutter with 2 hands. Always
hold the product tightly with thumbs and fingers
around the handles. Always hold the rear handle
with the right hand and the front handle with the left
hand.
24
Do not move the power
Do not use the side of the
Do not use a diamond
• Always be parallel to the cutting blade. Do not
be linearly behind the cutting blade. If there is a
kickback, the power cutter moves in the plane of the
cutting blade.
• Keep a safe distance to the cutting blade when the
engine operates.
• Make sure that you are in a stable position during
operation.
• Keep applicable distance from the object you are
cutting.
• Do not operate above shoulder height. Use a
platform or scaffold if the cutting operation is above
shoulder height. Do not overreach.
• Do not operate from a ladder.
• Make sure that the cutting blade is free when the
engine is started.
• Always monitor the product when the engine
operates.
• Do not move the product when the cutting blade
rotates.The product has a electrical retarder to
decrease the blade stop time.
1598 - 007 - 28.09.2023