KYT NF-R Manual De Instrucciones página 12

EN
USER'S INSTRUCTIONS
MICROMETRIC ADJUSTMENT RESTRAINT SYSTEM — Figure 1
Closing the strap – There are eight strap positions that allow to easily adjust the restraint
closure system, depending on the shape of the user's head.
1) Push the plastic lug (A) in to the guide (B) until the strap is fully secured and pushed firmly
against the jaw . Once closed, pull the strap firmly to check if it is securely fasten.
2) If it is not well secured, adjust the lenght of the strap by moving the band in the buckle (C).
Repeat the operation until the retention system is tightened correctly.
Releasing the strap – Release the plastic lug (A) by pulling (Y) the fabric edge (D) on the lug (B).
Release di strap and slip off the helmet
1
Q
X
22
2 3
F
Y
G
R
V
U
T
W
S
E
FRONT AIR INTAKE CHIN — E — Figure 2/3
The flow of incoming air in the front part of the helmet (chin) may be regulated by adjusting on
the middle part of the air intake:
- Figure 2: air intake closed.
- Figure 3: air intake fully open.
FRONT AIR INTAKE UPPER — F — Figure 4/5
The flow of incoming air in the upper front part of the helmet may be regulated by sliding the
cursor on the air intake:
- Figure 4: Slide the cursors forwards to completely close the air intake
- Figure 5: Slide the cursors backwards to completely open the air intake
FIGURE 1
E
FIGURE 2
F
F
EN
E
FIGURE 3
FIGURE 4
FIGURE 5
23