KYT NF-R Manual De Instrucciones página 16

EN
SUN VISOR — X
How to operate — Figure 15
The Visor has to be operated only by using the lifting lever (Y)
1) Opening the sun visor: Slide the lifting lever (Y)
2) Closing the sun visor: Slide the lifting lever (Y) in the opposite direction
Do not use the sun visor in rainy days, while driving through a tunnel, underpass or
when the light is low.
Y
X
1
Removing the sun visor — Figure 16
Open the visor until it is completely open.
Put the sun visor in the use mode. Release the sun visor by pushing it outwards and pulling it out
from its seat in the shell. Repeat the operations on the opposite side
Assembly
Hook the sun visor by pushing inwards and inserting it in the correct shell seat, repeat the
operations on the opposite side.
X
30
X
Y
2
FIGURE 15
Z
FIGURE 16
NOSE GUARD
Removal — Figure 17
The nose cover is snapped into place between the cap and the inner lining of the chin guard. To
remove it, all you have to do is pull it upwards.
Assembly — Figure 18
Place the nose cover in the middle of the visor's opening, inserting the tabs between the cap and
the chin guard. Press with force on the nose cover where the tabs are located until the lower
edge of the nose cover is fully adherent to the edge of the cap.
If this doesn't happen and the nose guard does not adhere to the edge of the shell or is not
positioned correctly, do not use the helmet and contact authorized personnel only.
FIGURE 17
FIGURE 18
EN
31