Publicidad
Idiomas disponibles
Idiomas disponibles
Note: Never operate the generator without the air filter in place.
Operating the generator without the air filter in place will result in
rapid engine wear.
Remove the air filter cover bolt (3) and remove the air filter cover (2).
Make sure that the air filter (1) is clean and not damaged. If the air filter
is dirty, wash the filter. If the air filter is damaged, replace the air filter.
Use a nonflammable solvent or a mixture of household detergent and
warm water to wash the filter. Rinse the filter thoroughly to remove all
of the cleaning solution. After the filter has dried, pour some engine oil
onto the filter. Then squeeze the filter to distribute the oil throughout the
filter and remove any excess oil.
Note: Do not wring out the filter. Wringing out the filter may damage
the filter.
Install the filter into the filter housing. Place the air filter cover over the
filter and reinstall the air filter cover bolt.
CYLINDER HEAD - CLEAN
Only qualified service personnel should perform this maintenance proce-
dure. Contact your local service center to schedule this maintenance.
ENGINE OIL LEVEL – CHECK
Always check the engine oil with the generator on a level surface and
with the engine stopped.
1. Remove the oil filler cap (1) and wipe the oil level gauge (2) to clean it.
2. Check the oil level by inserting the oil level gauge into the filler neck.
Do not screw the oil filler cap in when checking the oil level.
3. If the oil level is low (5), add the recommended engine oil until the oil
level reaches the upper mark (4) on the oil level gauge. Use the chart
below to determine which viscosity oil to use.
4. After adding oil, install and tighten the oil filler cap.
Note: Non-detergent and 2-stroke engine oils will damage the en-
gine and must not be used.
ENGINE OIL – CHANGE
1. Operate the engine until it reaches normal operating temperature. Stop
the engine and use a suitable container to collect the used oil.
2. Remove the oil filler cap (1) and drain plug (3) to drain the oil.
3. Reinstall the drain plug and tighten to 18 ± 2 lb ft (24 ± 3Nm).
4. Refill the oil and check the oil level. Refer to Engine Oil Level – Check.
5. Install and tighten the oil filler cap.
6. Dispose of the used oil properly
ENGINE VALVE LASH – INSPECT/ADJUST
Only qualified service personnel should perform this maintenance proce-
dure. Contact your local service center to schedule this maintenance.
FUEL LINE – REPLACE
Only qualified service personnel should perform this maintenance proce-
dure. Contact your local service center to schedule this maintenance.
FUEL TANK CAP AND STRAINER – CLEAN
Wipe off the fuel cap (1) and surrounding area before removing the fuel
cap. Wiping off the fuel cap and surrounding area before removing the
Operator's Manual
SERVICE
4
5
1
2
1
1
2
3
2
3
23
Publicidad
