Publicidad
Idiomas disponibles
Idiomas disponibles
1
1
3
24
Operator's Manual
fuel cap helps to reduce the amount of contaminants allowed into the
fuel system.
If there is a build-up of debris in the fuel strainer (2), remove the strainer
and rinse out the strainer. Allow the strainer to dry before installing the
strainer.
GENERATOR - INSPECT
Once a month start the engine and run the engine until it reaches normal
operating temperature (about 20 minutes). Plug in a corded device and
turn on the device to ensure that the generator is providing power. Once
you have verified that the generator is providing power, turn off the de-
vice and unplug it. Then turn the generator off.
SPARK ARRESTOR -INSPECT/CLEAN/REPLACE
2
This unit has a spark arrestor fitted to the exhaust outlet of the muffler.
The spark arrestor should be cleaned with a soft wire brush after every
50 hours or 3 months of use. The spark arrestor should be replaced after
every 100 hours of operation or if it becomes damaged
DO NOT perform this maintenance procedure until the muffler has
cooled.
Remove screws (2). Remove spark arrestor (1) Check the spark arres-
tor. Carefully clean the spark arrestor with a soft wire brush. If the spark
arrestor is damaged, replace the spark arrestor.
To install the spark arrestor, align the mounting holes in the spark arres-
tor with the mounting holes on the muffler. Insert screws (2) and tighten
securely.
SPARK PLUG – INSPECT/ADJUST/REPLACE
Refer to the Specifications section of this manual to determine the
4
proper spark plug part number and spark plug gap for your product.
2
1. Remove the side panel.
2. Remove the spark plug cap (3).
3. Use the plug wrench (1) to remove the spark plug.
4. Visually check the spark plug to see if it is damaged. If the insulator is
5. Measure the plug gap (4) with a feeler gauge. Adjust the gap as necessary
6. Check the spark plug washer to ensure proper working condition. If
7. Install spark plug and tighten to 16 ± 2 lb ft (22 ± 2 Nm). DO NOT
ENGINE (6000 AND 8000) MI-T-M
Spark Plug
Spark Plug Gap
Torque - New
Torque - Retighten
SERVICE
WARNING: HOT SURFACE HOT PARTS OR HOT COMPONENTS
CAN CAUSE BURNS OR PERSONAL INJURY. DO NOT
ALLOW HOT PARTS OR COMPONENTS TO CONTACT
YOUR SKIN. USE PROTECTIVE CLOTHING OR PROTECTIVE
EQUIPMENT TO PROTECT YOUR SKIN.
cracked, replace the spark plug. If the electrode is damaged, replace
the spark plug.
by carefully bending the side electrode. Refer to Specifications for the
correct gap for your product.
the washer is damaged, replace the washer.
overtighten as this may damage the engine.
f6Rtc
0.7 - 0.8 mm (0.03 in.)
8.7-10.9 ft-lb
16.6-19.5 ft-lb
Publicidad
