Publicidad
Idiomas disponibles
Idiomas disponibles
Training and Operating Instructions
28
GB
Change of power profiles
If the power is changed during program run, the change
becomes effective to the right of the blinking column. The
columns to the left of it show the rendered performance
values and remain unchanged.
Change from speed-independent to speed-
dependent operation
(running ergometer)
During training press "SET". A change from speed-depen-
dent to speed-independent operation takes place.
Display: both arrows under RPM
Pressing "SET" again switches operation back to speed-
independent.
Note:
The change from speed-dependent to speed-independent
operation is only possible in the programs "Count Up"
and "Count Down". The ERGORACER always starts
speed-independently. If training is interrupted, operation
switches back to speed-independent.
Interruption or end of training
For less than 10 pedal revolutions/min or pressing
"RECOVERY", the electronic equipment recognizes an
interruption of the training. The training data achieved are
displayed. Speed, power, revolutions and pulse are repre-
sented as average values with the Ø symbol.
With "Plus" or "Minus" you can change into the current
display.
The training data are displayed for 4 minutes. If during
this period no key is pressed and no training takes place,
the electronic equipment switches into the snooze mode
with room temperature display (display of the room tempe-
rature only SD4-9).
Resumption of training
When continuing the training within 4 minutes, the last
values are further counted or counted down.
G
Publicidad
