CYBEX gold Cloud G i-Size Guia Del Usuario página 11

PRODUCT PARTS
Newborn inlay (1)
Belt buckle (2)
Driving Direction Control (D.D.C.) (3)
Load leg (4)
ISOFIX-Release buttons (5)
ISOFIX-Locking arms (6)
Base (7)
ISOFIX-Anchorage points (8)
ISOFIX-Indicators (9)
Load leg adjustment button (10)
Load leg indicator (11)
Carrying handle (12)
Carrying handle release buttons (13)
Seat locking indicator (14)
Tilt angle indicator (15)
3-point automatic belt (16)
Lap belt guide (17)
THE CORRECT POSITION IN THE VEHICLE
This is an i-Size Enhanced Child Restraint System. It is approved according
to UN Regulation No. R129/03, for use in i-Size compatible vehicle seating
positions as indicated by vehicle manufacturers in their vehicle user manuals. If
your vehicle does not have an i-Size seating position, please check the vehicle
Type List. You can obtain the most up-to-date version of the Type List from
go.cybex-online.com/cloud-g-isize-car-compatibility.
Alternatively, the car seat may be installed on forward-facing vehicle seats
equipped with a 3-point automatic belt system.
It is not guaranteed that all sitting and reclining positions can be used in all
approved vehicles.
Diagonal belt guide (18)
Linear side-impact protection
(L.S.P.) (19)
Seat rotation and release handle (20)
Seat release handle (21)
Load leg parking position (22)
Headrest (23)
Headrest adjustment handle (24)
Shoulder harness outlets (25)
Belt adjustment button (26)
Shoulder belt (27)
Buckle tongue (28)
Central adjustment belt (29)
Sun canopy (30)
Driving direction indicator (31)
Release handle for lie-flat position (32)
Release button for stroller adapter (33)
DIFFERENT USES OF THE SEAT
40 – 87 cm, max. 13 kg
40 – 60 cm > 60 cm
The Newborn inlay (1) integrated at purchase should be removed if your child
is taller than 60 cm. To remove the Newborn inlay (1) open the belt buckle (2),
pull off the shoulder pads and remove the inlay.
INSTALLATION IN THE VEHICLE
Always ensure that...
• the backrest of the vehicle seat is locked in its upright position.
• when installing the car seat on the front passenger seat, adjust the vehicle
seat as far back as possible.
�� The infant car seat is exclusively made for forward facing car seats, which
are equipped with ISOFIX or with a 3-point belt system.
Installation of the car seat with Base G
1. Keep the Driving Direction Control (D.D.C.) button (3) completely
downward.
2. Fold out the Load leg (4) until it locks into its foremost position.
3. Release the ISOFIX-Release buttons (5) to extend the ISOFIX-Locking
arms (6).
The ISOFIX-Release buttons can both be released independently allowing
��
the ISOFIX-Locking arms to be adjusted independently.
40 – 60 cm > 60 cm
EN
7