Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
C4.;
ADAPTING MICROWAVE
BLOWER
FOR
RECIRCULATION (cont.)
Place the blower unit back into the opening.
CAUTION:
Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
EJ Secure blower unit to microwave with the screw
removed in Step 4.
9 | Replace blower plate with the screw removed in
Step 1.
Back of
"*- Microwave
OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT:
If filler blocks are not used,
case damage may occur from overtightening
screws.
21
NOTE: When mounting
the microwave oven,
thread power cord
through hole in bottom of
top cabinet. Keep it tight
throughout Steps 1-3. Do
not pinch cord or lift
oven by pulling cord. ~\y.
11 |Lift microwave, tilt it
forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting
plate.
[2 | Rotate front of oven
up against cabinet
bottom.
Insert a self-aligning screw through top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
Cabinet Front
J
Cabinet Bottom Shelf
7
A
Filler Block
Equivalent to Depth
of Cabinet Recess
SS.
\
\
Self-Aligning Screw
Microwave Oven Top
| 4 | Attach the microwave oven to the top cabinet.
Publicidad
