Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
NOTE: If you need to install ducts, note that the total
duct length of 34" x 10" rectangular or 6" diameter
round duct should not exceed 140 equivalent feet.
Outside ventilation requires a HOOD EXHAUST DUCT.
Read the following carefully.
NOTE: It is important that venting be installed using
the most direct route and with as few elbows as possible.
This ensures clear venting of exhaust and helps prevent
blockages. Also, make sure dampers swing freely and
nothing is blocking the ducts.
Exhaust connection:
The hood exhaust has been designed to mate with
a standard 34" x 10" rectangular duct.
Ifa round duct is required, a rectangular-to-round
transition adaptor must be used. Do not use less than
wt
s
a 6" diameter duct.
Maximum
duct length:
For satisfactory air movement, the total duct length of
34%" x 10" rectangular or 6" diameter round duct should
not exceed 140 equivalent feet.
Elbows, transitions, wall and roof caps,
etc.,
present additional resistance to airflow and are
equivalent to a section of straight duct which is longer
than their actual physical size. When calculating the total
duct length, add the equivalent lengths of all transitions
and adaptors plus the length of all straight duct sections.
The chart below shows you how to calculate total
equivalent ductwork length using the approximate feet
of equivalent length of some typical ducts.
EQUIVALENT
NUMBER
EQUIVALENT
DUCT PIECES
LENGTH
x
USED
=
LENGTH
Rectangular-to-Round
5 Ft.
x
{
}
=
Ft
Transition Adaptor*
T_)
Wall Cap
AQ Ft.
x
(
}
=
Ft
OD
30° Elbow
10 Ft.
x
(
}
=
Ft
QD
45° Elbow
5 Ft.
x
(
}
=
Ft.
CE
90° Elbow
25 Ft.
x
( )
=
Ft
A
45° Elbow
5 Ft.
x
( )
=
Ft
eS
Roof Cap
24 Ft.
x
()
=
Ft.
Straight Duct 6" Round or
1 Ft.
x
(
}
=
Ft.
34" x 10" Rectangular
Total Ductwork
=
Ft.
* IMPORTANT:
If a rectangular-to-round transition
Equivalent lengths of duct pieces are based on actual tests
>
adaptor is used, the bottom corners of the damper
and reflect requirements for good venting performance with
will have to be cut to fit, using the tin snips, in order
to allow free movement of the damper.
any vent hood.
5
Publicidad
