Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
1
|PLACEMENT OF THE MOUNTING
PLATE
A.| REMOVING THE MICROWAVE
OVEN FROM THE CARTON/
REMOVING THE MOUNTING
PLATE
1 | Remove
the installation instructions, filters, glass
tray and the small hardware bag. Do not remove
the Styrofoam protecting the front of the oven.
Fold back all 4 carton flaps fully against carton
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in
the Styrofoam.
7
A
Carton
"hs,
y
Styrofoam
Pull the carton up and off the oven.
4 | Remove and properly discard plastic bags.
Mounting
Plate
[5 | Remove the 2 screws from the mounting plate.
This plate will be used as the rear wall template
and for mounting. You may discard these screws.
B.| FINDING THE WALL STUDS
Wall
Studs
Center
MY
1 | Find the studs, using one of the following
methods:
A. Stud finder — a magnetic device which
locates nails.
OR
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound.
This will indicate a stud location.
[2 | After locating the stud(s), find the center by
probing the wall with a small nail to find the edges
of the stud. Then place a mark halfway between
the edges. The center of any adjacent studs should
be 16" or 24" from this mark.
Draw a line down
the center of the studs.
THE MICROWAVE
MUST BE CONNECTED
TO
AT LEAST ONE WALL STUD.
Publicidad
