GE 22 Manual Del Propietario E Instalación página 11

About the automatic icemaker, gecom
A newly installed refrigerator may take 12 to 24 hours to begin making ice.
Automatic Icemaker
Power
Switch
Icemaker
PowerLight _rArm
The icemaker will produce sexen cubes
per c)'cle>--al)proxintately 100-130 cubes
in a 24-hour period, depending on fl'eezer
coi/tpai'ttllent tei/tpei'attti'e, i'ooi/t
temperature, number of door ol)enings
and other use conditions.
See below fin" how to access ice and reach
the power switch on dispenser models.
If the refl_igerator is operated befin'e the
water cmmection is made to the icemaket;
set the power switch in the 0 (off) position.
When the refl-igerator has been com_ected
to the water SUl)l)ly, set the power switch to
the I (on) position.
The icemaker will fill with water when it
cools to 15°F (-10°C). A newly installed
refi_igerator may take 12 to 24 h ours to begin
nlaking ice cubes.
You will hear a buzzing sotmd each dine
the icemaker fills with water:
Throw awm the first tew batches of ice to
allow the water line to cleat:
Be sm'e nothing interteres with the sweep
of the teeler amt.
When the bin fills to the level of the teeler
am_, the icemaker will stop producing
ice. It is nomml fin" several cubes to be
joined together:
If ice is not used fl'equenfl> old ice cubes
will become cloudy, taste stale and shrink.
NOTE."In homes with lower-than-averagewater
pressure,you may hear the icemaker cyclemultiple
times when making one batch of ice.
Models without a shelf
above the ice bin
Toaccessice andreach the
icemakerpower switch:
o Lift flTebin, then pull it
forward until the bin stops.
Lower the bin to access ice
or reach the power switch.
NOTE:In order to take full advantage
of the tilt-out ice b#7,only store items
on the shelf below the ice b#7that
are no tafler than the Iowest poflTt
on the bin.
Accessing Ice and Reaching the
Power Switch on Dispenser Models
There are two types of ice storage bins on
dispenser models. One has a shelf aboxe
the bin, the other does not.
Special note about dispenser models
without a shelf above the ice bin:
ii;:These models have a tilt-out ice bin.
The bin can be tilted out as shown in
the illustrations, and it will hold itself
up while you take ice out or tm'n the
icemaker power switch on and off.
Be sm'e to put the bin back in place
befl)re
closim* the (loot:
To restore your ice level from an empty
e o menae : " et s e,'he ste s
12 hom_ atter the first batch ofice
O
has fifllen into the bin, dispense
3 to 4 cubes.
@ _Mter an additional 6 hems, dispense
3 to 4 cubes again.
Models with a shelf
above the ice bin
Toaccessice, pullthe binforward.
Toreach the power switch, pull the
shelf straight out Always be sure to
replace the shelf.
These steps will restore your ice level
in the shortest ai//otlnt
Of time.
11