Publicidad
The walking
foot accessory
* The walking
foot accessory
is optional.
It is not included
with this machine.
Always
try
to
sew
first
without
the
walking
foot
accessory
which should
be used only when necessary.
It is easier to guide the fabric and you have a better view of
the seam when using the standard,
regular foot on your
machine. Your EURO-PR©
sewing machine offers excellent
stitch
quality
on a wide
range of fabrics
from delicate
chiffons to multiple layers of denim.
The "Walking
foot" accessory
equalizes
the feeding of the
upper and lower layers of fabric and improves the matching
of plaids, stripes
and patterns.
This foot helps to prevent
uneven feeding of very difficult fabrics.
1. Lift the presser foot bar.
2. Remove the "foot holder" by opening counter
clockwise
the presser bar attaching screw. (3)
3. Attach the "walking foot" to the machine in the following
way.
i) The fork arm should
fit into the needle
screw
and
clamp. (2)
ii) Slide the plastic "attaching head" from your left to right
so that it is fitted into the "presser foot bar".
iii) Lower the "presser foot bar".
iv)Replace
and
tighten
clockwise
the
"presser
bar
attaching screw".
4. Make sure both the "needle screw" and the "presser bar
attaching screw" are tightly secured.
5. Draw the bobbin thread
up and place both the bobbin
thread
and the needle thread behind
the walking
foot
attachment.
a. Fork arm
b. Attaching head
c. Needle bar
d. Needle screw & clamp
e. Presser foot bar
f. Presser bar attaching screw
94
Publicidad
