Publicidad
Monogramming
and embroidering
with embroidery
hoop*
Set the machine as illustrated.
Remove the presser foot and the presser foot
holder.
Move the drop feed control to right side to
lower the feed dogs. (1)
Lower presser foot lever before starting to sew.
Adjust the stitch width according to the size of
lettering or design.
Preparation
for Monogramming
and Embroidering*
- Draw the desired lettering or design on the right side of the fabric.
- Stretch the fabric between embroidery hoop as firmly as possible.
- Place the fabric under the needle. Make sure the presser foot bar is down in its lowest
position.
- Turn the balance wheel towards you to bring up the lower thread through the fabric.
Sew a few securing stitches at the starting point.
- Hold the hoop with thumb and forefingers of both hands while pressing the material with
the middle and third fingers and supporting the outside of hoop with smaller finger.
* Embroidery hoop not included with machine.
,5
O
@
84
Publicidad
