Publicidad
Idiomas disponibles
Idiomas disponibles
EN
note
The chemical/water ratio is 7:1 for every 26,5 liters of water pumped, 3,8 liters of chemical/cleaning solution will
be used.
3. Install low pressure (black) nozzle into quick connect fitting of spray wand. See "To use spray wand" paragraph in this
section.
4. After use of chemicals, place chemical hose into container of clean water and deaw clean water through chemical injection
system to rinse system thoroughly. If chemicals remain in the pump it could be damaged. Pumps damaged due to chemicals
will not be covered under warranty.
note
Chemicals and soaps will not siphon when spray wand is in the high pressure setting.
READ AND UNDERSTAND ALL WARNINGS BEFORE STARTING UNIT
DANGER!
When using the high pressure setting. DO NOT allow the high pressure spray to come in contact with unprotec-
ted skin, eyes, or with any pets or animals. Serious injury can occur.
Your pressure washer operates at fluid pressures and velocities high enough to penetrate human and animal flesh, which could
result in amputation or other serious injury. Leaks caused by loose fittings or worn or damaged hoses can result in injection
injuries. DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a plysician immediately!
warning!
NEVER fill fuel tank when engine is running or hot. Do not smoke when filling fuel tank.
NEVER fill fuel tank completely. Fill tank to 1/2 below bottom of filler neck to provide space for fuel expansion. Wipe any fuel
spillage from engine and equipment before starting engine.
NEVER run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an odourless
and deadly gas.
DO NOT let hoses come in contact with very hot engine muffler during or immediately after use of your pressure washer. Danage
to hoses from contact with hot engine surfaces will NOT be covered by warranty.
caution!
NEVER pull water supply hose to move pressure washer. This could damage hose and pump inlet.
DO NOT use hot water, use cold water only.
NEVER run water supply off while pressure washer engine is running or damage to pump will result.
DO NOT stop spraying water for more than 2 minutes at a time. Pump operates in bypass mode when spray gun trigger is not
pressed. If pump is left in bypass mode for more than 2 minutes, internal components of the pump can be damaged.
11
Publicidad
