Publicidad
Idiomas disponibles
Idiomas disponibles
EN
GAS
OIL
WATER
PRESSURE ADJUSTMENT
PUMP
BY-PASS MODE
THERMAL RELIEF VALVE
HOSE
ENGINE
SOAP/CHEMICALS
NOZZLE
MAINTENANCE
STORAGE OR WINTERIZING
Use fresh high quality unleaded gas.
Add stabilizer to fuel tank and run engine for 5 minutes before
storage.
Pump oil: refer to owners manual supplied with this unit.
Engine oil: refer to the engine manual supplied with this unit.
Some units are equipped with a low oil sensor and adequate oil must
be added or the unit will not start.
Use only cold water.
Do not operate unit with clogged or missing water filter/screen.
Do not operate unit without adequate water supply to pump. Adequate
water supply is a minimum of 20 psi and 5 gpm.
The pressure setting is preset at the factory to achieve optimum clea-
ning. If you need to lower the pressure setting, refer to the operation
manual for proper procedure.
Pull gun trigger every 2 minutes while engine is running.
Do not allow water to freeze in pump.
For cold wather or long term storage refer to the operation manual for
proper procedure.
Never leave unit running for more than 2 minutes without pulling gun
trigger. Doing so, could cause damage to pump and avoid warranty.
Pump is equipped with a thermal relief valve. If the water overheats,
this valve will open and allow a gush of water to escape. Once the
water is released, the valve closes allowing the pump to operate
normally.
Do not allow hoses to contact the hot engine muffler during or after
use. Never pull the hose to move the unit.
Do not adjust or attempt maintenance without consultiong engine
manual or an authorized engine service center. Add stabilizer to fuel
tank and run engine every 5 minutes before storage. Always turn on
the water before starting the engine.
Use only soaps and chemicals designed for pressure washer use.
Keep nozzle unclogged. Refer to manual for cleaning procedures.
Chemical/soap cannot be applied in high pressure setting. Only in
low setting.
Follow recommended maintenance schedule for engine and pump.
Refer to manuals.
Draw clean water through chemical inlet.
Add stabilizer to fuel tank and run engine for 5 minutes before
storage.
Do not allow water to freeze in pump, gun, spray wand or hoses.
For cold weather or long term storage, refer to the operation manual
for proper procedure.
18
Publicidad
