Daikin FTXP20N5V1B9 Manual De Instrucciones página 8

5 Unit installation
b
a
a Upper hook
b Symbol with 3 circles
4 We recommend opening the flap before removing the front
grille.
5 Place both hands under the centre of the front grille, push it up
and then toward you.
5.2.4 To re-install the front grille
1 Install the front grille and firmly engage the 3 upper hooks.
2 Install 2 screws back on the front grille.
3 Install the air filter and then mount the front panel.
5.2.5 To remove the electrical wiring box cover
1 Remove the front grille.
2 Remove 1 screw from the electrical wiring box.
3 Open the electrical wiring box cover by pulling the protruding
part on the top of the cover.
4 Unhook the tab on the bottom and remove the electrical wiring
box cover.
a
b
a
c
a Tab
b Protruding part on the top of the cover
c Screw
5.2.6 To open the service cover
1 Remove 1 screw from the service cover.
Installation manual
8
2 Pull out the service cover horizontally away from the unit.
a
5.3
5.3.1
1 Install the mounting plate temporarily.
2 Level the mounting plate.
3 Mark the centres of the drilling points on the wall using a tape
measure. Position the end of tape measure at symbol " ".
4 Finish the installation by securing the mounting plate on the wall
using M4×25L screws (field supply).
A
3
5.3.2
a
1 Bore a 65 mm large feed-through hole in the wall with a
downward slope towards the outside.
2 Insert a wall embedded pipe into the hole.
3 Insert a wall cover into the wall pipe.
a b
a Service cover screw
b Service cover
Mounting the indoor unit
To install the mounting plate
INFORMATION
The removed pipe port cover can be kept in the mounting
plate pocket.
a
b c a
1 17
213
d
a
e
h g
a
48
170 50
337
770
A Mounting plate for class 20~35
a Recommended mounting plate fixing spots
b Pocket for the pipe port cover
c Tabs for placing a spirit level
d Through-the-wall hole Ø65 mm
e Drain hose position
f Position for the tape measure at symbol " "
g Gas pipe end
h Liquid pipe end
To drill a wall hole
CAUTION
For walls containing a metal frame or a metal board, use a
wall embedded pipe and wall cover in the feed-through
hole to prevent possible heat, electrical shock, or fire.
NOTICE
Be sure to seal the gaps around the pipes with sealing
material (field supply), in order to prevent water leakage.
FTXP20~35N5V1B9 + ATXP20~35N5V1B9
c a
116.5
237
d
f
A A
e
a
a
170 48
337
(mm)
Daikin room air conditioner
3P748643-1 – 2023.07