Publicidad
Idiomas disponibles
Idiomas disponibles
30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with an Electric Oven and a Gas Cooktop)
8 | Leveling the Range -
Level the range after installation in the cutout
opening.
1. Open the range drawer. The leveling screws control
the height of the rear leg.
2. Adjust the appliance legs as follows until the
underside of the cooktop surface is sitting level on
the countertop (Figure 12).
Rear Leveling
Device
5
Use this Screw
to Adjust Rear Leveling
Device Height
A. To adjust the front leveling legs, use a wrench and
turn counterclockwise to lower or clockwise to raise.
B. To adjust the rear leveling screws, use a ratchet or
a nut driver and turn counterclockwise to lower or
clockwise to raise.
3.
Check if the range is level by installing an oven rack
in the center of the oven and placing a level on the
rack (Figure 13)
4.
Take 2 readings with the level placed diagonally in
one direction and then the other. Level the range, if
necessary, by adjusting the leveling legs.
5.
If the range is not level, contact a carpenter to
correct sagging or sloping floor.
Figure 13
11
9
Decorative Rear Trim Installation
(if required)
Disconnect the power from the range.
Make sure the range is leveled.
Pull range toward you.
Measure the distance between the floor and the
surface underneath the cooktop frame.
5.
Mark that distance on the wall where the decorative
trim will be installed.
Draw a line.
Place the top of the decorative trim under that line.
8.
Using the screws provided fix the decorative trim into
the wall.
9.
Slide the range back into position as far as it will go
and reconnect the power source.
Decorative Trim
-
Distance between
|
" |
the floor and
the surface
underneath the
cooktop frame.
Figure 14
Et) Check Operation
Refer to the Use and Care Guide packaged with the
range for operating instructions and for care and
cleaning of your range.
Do not touch the elements or burners. They may be hot
enough to cause burns.
Remove all packaging from the oven before testing.
1.Install Burner Bases and Burner Caps
This range is equipped with sealed burners as
shown (see Figure 15 on next page).
1. Unpack burner bases and burner caps.
2. Place burner bases over each gas opening.
3. Make sure the burner is properly aligned and leveled.
Place burner caps over appropriate burner bases.
Publicidad
