MR TAPCON 230 Manual página 34

34
Mounting 7820658/06 EN
Figure 30: Example of a soldered shielding on a plug housing
Connection
1. Connect the D-SUB 9-pole connector to the COM-X3 interface.
2. Connect the COM-X1 RJ45 interface to the CPU-X5 interface using the sup-
plied patch cable.
5.4.5.3 Fiber-optic cable
To ensure error-free data transmission, observe the information from the man-
ufacturer of the fiber-optic cable and the following instructions:
– Radii must not fall below the minimum permissible bend radii (do not bend
fiber-optic cable).
– The fiber-optic cables must not be over-stretched or crushed. Observe the
permissible load values.
– The fiber-optic cables must not be twisted.
– Be aware of sharp edges because they can damage the fiber-optic cable's
coating during laying or can place mechanical loads on the coating later on.
– Provide a sufficient cable reserve near distributor cabinets. Lay the reserve
such that the fiber-optic cable is neither bent nor twisted when tightened.
Fiber-optic cable, 1,310 nm Multimode
1. Slide the SFP module into the COM-X4 interface
.
Figure 31: Engaging the SFP module
and fold down the clasp