Publicidad
Idiomas disponibles
Idiomas disponibles
Setting the stroke rate (figure 6).
Set the required stroke rate according to the
material being worked.
The stroke rate can be preset in 6 steps with
the control knob for continuously variable
stroke adjustment.
Operate the power tool in continuous
operation only at the highest stroke rate set-
ting (6).
The stroke rate settings (1 ... 5) are to be
used only for brief cuts where, for example,
exact cutting along a cutting line is required.
This applies in particular to work with mate-
rials with the maximum possible material
thickness.
Continuously variable stroke
Fig. 6
adjustment
6
5
820 /min
4
700 /min
600 /min
en
3
2
500 /min
1
380 /min
260 /min
15
Publicidad
