Publicidad
Idiomas disponibles
Idiomas disponibles
English
7 . Wall mounting
The electric radiaotrsmust be mounted on the wall following the
instructions provided in the packaging of fastening supports .
When the radiator is in the proper position, the resistor is located at the
bottom right . The radiator must absolutely never be installed with the
resistor turned upwards or in any direction other than pointing downwards,
as the heating element in the resistor itself would be irreversibly damaged
during operation . Never position the radiator in front of the power socket .
Make sure that the resistor never operates unless it is fully submerged .
YES
YES
8 . Connecting up
All models of Cordivari electric radiator are fitted with a power cable
complete with a pre-mounted Shuko plug . Before connecting up, make
sure that the rated voltage of the appliance (230V) corresponds with the
mains voltage, and also check to ensure that the wall socket is properly
earthed in compliance with current regulations and that it is capable of
delivering the rated current required to operate the chosen model at full
power .
9 . Cautions
When operating normally the radiaotr has very hot surface . It is normal
for the bottom pipes not to heat up . Only warm towel that has been
washed in water . The resistors on electric radiators must never operate
without filling fluid, and for this reason the connections on the radiator
itself must never be opened .
In the event of accidental overheating and/or improper use, the resisitor
circuit may cut out . In this event the resistor can no longer be used, and
must be replaced .
10 . Replacing of electrical immersion
Should it be necessary to replace the resistor, this must be
done exclusively by the manufacturer, by a person with suitable
qualifications, so as to avoid any risks .
11 . Operation
11.1 Scheme
• Buttons overview
NO
NO
NO
1
2
1 . Infrared receiver
2 . Button power on/standby mode
3 . Selecting operating modes .
4 . Plus and minus buttons, used to set temperatures, time, date and
programmes .
5 . Save settings
6 . Boost
• Indicators overview
1
2
3
1 . Boost indicator light
2 . Gauge consumption
3 . Heating indicator
4 . Days of the week (1=monday . . . 7= sunday)
5 . Setting temperature
6 . Open window detection indicator .
7 . Keypad locked
8 . Radio transmission indicator
9 . Operating modes
Auto mode
Comfort mode
Eco mode
Frost protection mode
Time and date setting mode
Programming mode
Setting
Important: In Auto, Comfort, Eco and Standby mode, backlight turns
off automatically after 20 seconds if no buttons are pressed . It will be
necessary to reactivate it by pressing one of the keypad buttons before
making settings .
- 26 -
2
3
5
4
9
2
4
5
Cod . 1910000000276 - nv04
6
8
7
6
Publicidad
