Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 8: ADD ENGINE OIL
1.
Make sure the log splitter is on a flat, level surface.
2.
Remove the oil fill cap / dipstick to add oil.
3.
Refer to the separate owner's engine manual for the amount needed of SAE10W-30 engine oil. Replace the
oil fill cap / dipstick.
4.
Check engine oil level daily and add oil as needed.
NOTE: During the break-in period, check the engine oil level often.
ATTENTION: Do not attempt to crank or start the engine before filling it correctly with the
recommended type and quantity of oil. Damage to the log splitter as a result of failure to follow
these instructions will void the warranty.
STEP 9: ADD GASOLINE TO ENGINE
1.
Use only clean, fresh, regular unleaded fuel with a minimum 86 octane rating.
2.
Do not mix oil with fuel.
3.
With the engine off, remove the fuel cap and slowly add fuel to the tank. Do not overfill, allow approximately
¼ inch of space for fuel expansion.
4.
Screw on the fuel cap and wipe away any spilled fuel.
ATTENTION: Please take into account the rules on "Use of combustibles safety" in this manual on
the "Use of combustibles safety" section.
STEP 10: ADD HYDRAULIC OIL
1.
The log splitter needs to be on a flat, level surface before adding the hydraulic oil.
2.
Remove the oil cap from the hydraulic oil tank.
3.
Add approximately 1.37 gallons of hydraulic oil, 10W AW, AW-32, ASLE H-150, ISO 32, Universal Hydraulic
Fluid or Dexron III Transmission Fluid.
4.
Check the hydraulic oil level.
5.
Start the engine and use the control lever to extend and retract the wedge several times to remove air from
the lines.
6.
With the wedge retracted, check hydraulic oil level again and top up if necessary.
61
EN
Publicidad
