Publicidad
Idiomas disponibles
Idiomas disponibles
8
millnorway.com
temperature drops below this level, the heater will automatically start again. When
the room has reached the desired temperature again, the heater will turn itself off.
4. The thermostat goes from 5 to 35°C.
5. If you want to change the temperature in the room, repeat step 3.
6. Press the fan button to start the fan (does not apply to CO2200LEDMAX).
the fan is only active when the heater is heating up
is on).Timer function for CO2200LEDMAX: Press and hold the timer button for 3
seconds to activate the timer function, 00 will appear in the display. Turn the timer
button to select how many hours 0-24 you want the timer function to be activated, 0
means no timer function. Aer selecting the number of hours, press the timer button,
or wait 15 seconds for automatic confirmation. The timer indicator will now light up.
When the timer function is o, the heater goes to standby mode, the display shows
OF and the standby indicator will light up.
7. The heater has an overheat protection that turns the device off if any parts become
extremely hot.
8. If the temperature sensor is not functioning as it should,
display. In such instances, the heater will switch itself off. Please contact your
distributor or importer.
9. To turn off the heater, press the ON/OFF button. Should the heater be left unused
for a longer period of time, pull out the plug.
Temperature calibration
SG2000LED/SG2000LED BLACK/SG2000GLASS
See figure 6 on separate illustration sheet
It may occur deviation between the temperature registered by the heater and the actual
temperature in the room. This can be caused by several reasons, however, the most
comon is that the heater is placed in a fair distance from where you usually reside. When
you set the temperature to for example 22 degrees, it is only natural that you expect the
same temperature where your sofa is placed for instance. However, the temperature
sensor is placed on the product itself, and therefore a deviation in temperature may occur.
To adjust this, all Mill heaters are equipped with a calibration function, which enables you
to adjust the temperature registered by the heater. N.B! The room must have achieved a
stable temperature before any calibration.
Press and hold
in the room. Confirm with
Resetting the heater
See figure 7 on separate illustration sheet
Turn off the heater's main switch. Press and hold
heater's main switch.
@
for 5 seconds and use + or – to set the actual temperature observed
@
or wait 15 seconds for automatic confirmation.
(when the power indicator
$
will be shown on the
@
%
or
while you turn on the
Note that
Publicidad
