mill SG2000MEC Manual De Montaje E Instrucciones página 8

6 millnorway.com
Assembly
A
See figure 3 on separate illustration sheet
Mechanical Thermostat
1. Insert both legs into the brackets so you get a stable foot.
2. Remove the pre-mounted screws from the bottom of the heater and place the heater
gently on its head to mount the feet.
3. Two screws must be fastened on each foot bracket.
4. NEVER USE THE HEATER BEFORE THE LEGS HAVE BEEN TIGHTLY SCREWED
B
Electronic Thermostat
1. Remove the pre-mounted screws on both legs before you insert them into thebrack-
ets, so that you get a stable foot.
2. Attach the legs to the brackets by tightening 2 screws into each bracket.
3. Remove the pre-mounted screws from the bottom of the heater and place the heater
gently on its head to mount the feet.
4. Two screws must be fastened on each foot bracket.
NEVER USE THE HEATER BEFORE THE LEGS HAVE BEEN TIGHTLY SCREWED.
5.
Instructions mechanical thermostat
Please see table on page 5 for which models that have mechanical thermostats
Control Panel
See figure 4 on separate illustration sheet
1. Thermostat: Adjust the desired heat settin
A
2. Output selector:
0: OFF
|: 750W
||: 1250W
|||: 2000W
WARNING:
INSTRUCTIONS BEFORE USING THE HEATER!
ATTENTION!
must not be used without supervision
Usage mechanical thermostat
1. Set the output selector to the OFF position (0) and the thermostat to minimum. Plug
the heater into a grounded outlet.
SG2000MEC
BE SURE THE FOOT IS FITTED CORRECTLY AND ACCORDING TO THE
This heater is only meant to be used as a supplementary heating source, and
B
CO2200MECMAX
0: OFF
|: 1000W
||: 1200W
|||: 2200W