Publicidad
Idiomas disponibles
Idiomas disponibles
REF. 53930
ASSEMBLY
STEP 1
1.
Attach Front Stabilizer (2) to Main Frame (1) using
2pcs of CARRIAGE BOLT M8*53 (50), 2pcs of WAS-
HER Φ 8 (51) and 2pcs of DOMED NUT M8 (52).
2.
Repeat step A to install Rear Stabilizer (3) to Main
Frame (1).
3.
Lever the machine: The user can tighten or loose 4
x LEVEL FOOT Φ38*M8 (10) to level the machine if
needed.Tighten 4 x LEVEL FOOT Φ38*M8 (10) to
make the machine stable before starting workout.
STEP 2
4.
Loosing SPRING LOCK KNOB (25) and pull out, in-
sert Seat Post (4) into the rear opening tube of the
Main Frame (1). Adjust the Seat Post (4) to your desi-
red height, then tighten the SPRING LOCK KNOB
(25).
5.
Place Seat Slider (6) onto Seat Post (4), then fixing
them with WASHER Φ10 (46) and OCTAGONAL
KNOB M10(44).
6.
Place Seat (45) onto Seat Slider (6), secure seat
by tightening the seat locking nuts (Pre-fitting on the
Seat).
STEP 3
Las dos partes deben estar en el mismo lado cuando se conectan
1.
Insert Handlebar Post (5) into the front opening
tube of the Main Frame (1). Tighten SPRING LOCK
KNOB (25).
2.
Attach Handlebar (7) onto Handlebar Post (5) with
4 sets of HEXAGON BOLT (42) and WASHER Φ8
(51). Then place the Phone Holder (36) on Handle-
bar (7), and press it down.
3.
Attach the Monitor Holder (40) to Handlebar (7), fix
using Lock Bolt (53). Insert Monitor (37) into Monitor
Holder (40). Then connect the Sensor Wire (23) from
Monitor (37) to the Sensor Wire (23) from Main Fra-
me (1) and Handlebar (7).
STEP 4
NOTE: The RIGHT PEDAL (11) has R stamped on the end of the
pedal shaft. The RIGHT PEDAL (11) has right hand threads and
is tightened by turning clockwise. The LEFT PEDAL (12) has L
stamped on the end of the pedal shaft. The LEFT PEDAL (12) has
left hand threads and is tightened by turning counter clockwise.
1.
Thread the RIGHT PEDAL (11) into the right side of
the RIGHT CRANK (15) as shown. Tighten the pe-
dal securely. Select the RIGHT PEDAL STRAP (13)
which has R marked on the bottom side of the strap.
Snap the two-hole end to the inside edge of the RI-
GHT PEDAL (11). Snap the other end to the outside
edge of the RIGHT PEDAL (11) with the R mark on
the bottom of the RIGHT PEDAL STRAP (13). Select
adjustment holes which allow your foot to be easily
removed from the pedals.
2.
Use the same procedure to attach the LEFT PEDAL
· 7 ·
Publicidad
