Product Features; Mounting Charger To A Flat Surface; Control Panel - DSR INDUSTRIAL Serie Manual Del Usuario

10.

PRODUCT FEATURES

1
4
11.

MOUNTING CHARGER TO A FLAT SURFACE

Do not mount charger in a location with restricted air flow. The area
where the charger is to be fastened must be dry, well ventilated and
away from any combustible material and fumes.
11.1 Turn off and disconnect charger.
11.2 Place the back of the charger with mounting bracket against a secure, flat
surface.
11.3 Securely mount charger to a flat surface with a minimum of one and a half
inches of clearance on each side.
12.

CONTROL PANEL

12.1 POWER ON (red) LED
charger is plugged in and receiving AC power.
5
1. Charger Status LEDs (located on side of unit)
2. Battery Clamp Output Cord
3. 3 Pin XLR 3-12C Output Cord
4. 3/8" Dia. Ring Terminal Output Cord
5. AC Cord
– The red POWER ON LED lights up when the
6
• •
2
3