Kenmore 31510 Manual De Uso Y Cuidado página 10

About Boundary Strips
The boundary strips allow you to keep the
robot from entering an area or picking up
an item that the robot should not clean.
The robot will recognize the boundary
strips and will not cross into the blocked-
off area.
Boundary Strip Installation
Instructions
1. Identify the area or item where you want
to install the boundary strips.
2. If necessary, use scissors to cut the
boundary strip to a shorter length. Be
sure to correctly measure the length
before cutting. Do not reduce the width
of the boundary strips by cutting down
the middle of the strip.
USAGE TIPS
3. Apply adhesive tape to lay the boundary
strip flat on the floor. Make sure the strip
is placed flat on the floor or under a
rug.
NOTE:
is placed on the same surface plane the
robot is used on. Be careful not to damage
the floor when using adhesive tape. It is
not recommended for use on carpets. Keep
the boundary strip away from objects that
emit excessive heat.
- 10 -
Make sure the boundary strip