Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
12. Glass
13. Top right cooking area
14. Bottom right cooking area
15. Control panel
Note: Images are for reference only. The
actual contents may vary depending on
the model.
In order to know more about the product
features, see table 01 on page 10.
ASSEMBLY AND INSTALLATION
Before
using
this
the
packaging
the product. If the appliance could be
damaged, contact the selling point where
you purchased it.
• Verify that the electrical installation
in your home is suitable to install this
appliance.
• See image 24 on page 9 to visualize the
electrical connections.
• UniversalBlue
accountable
installations (not described in this
manual) or carried out by non-qualified
personnel
• The manufacturer will not be held
accountable for any damage caused by
an incorrect installation.
• Remove all protective sheets and
adhesive tape before using it for the
first time.
Remember that the hob must
not be sealed with silicone. The
warranty will no longer be
valid if this happens.
For
both
types
induction), please follow the following
instructions before installation:
• The installation surface must be flat
and levelled, and no other structural
part must interfere in the space
requirements.
• Keep
the
minimum
described in the following images
38
appliance,
remove
and
carefully
inspect
will
not
be
for
inappropriate
(glass-ceramic
distances
• Image 22 on page 9
• Image 23 on page 9
• The material of the installation surface
must be heat resistant.
• If the cooking hob is installed on top
of an oven, make sure the oven has a
cooling fan incorporated.
• The installation must comply with all
legal requirements, regulations and
applicable laws.
• There must be an isolator switch in
the final installation that allows total
disconnection from the main power
supply, installed and located so that
it
complies
concerning electrical installations.
• This switch must be certified and there
must be a 3 mm isolating distance
between all the poles (or between all the
conductors if the pertinent regulations
concerning
allows this change)
• The disconnect switch must be easily
accessible to the end user after the
installation.
held
• Check with your local authorities if you
have any doubt about the installation
• Use materials which are heat resistant
and easy to clean (for example, tiles) for
the finishings around the hob.
Installation process
• Cut the worktop according to the
measures indicated on image 22 on
page 8.
• For the purpose of the installation and
use, you must keep at least 5 cm around
the opening.
• Make sure the thickness of the worktop
is at least 30 mm.
• Make sure that under any circumstance
the cooking hob is well ventilated and
and
that the air inlet and outlet are not
blocked, as described on image 23 on
page 9.
• Make the electrical connections as
described on image 24 on page 9.
• Fit the cooking hob in the opening and
resting on the worktop..
as
After installing the hob, make sure that
with
the
regulations
electrical
installation
Publicidad
