Technical Data; Fuel Specifications - Truper COS-26X Manual De Instrucciones

Technical data

Description
Net weight
Fuel tank
Type of blade
Blade length
Sound level
Duty cycle

Fuel specifications

• The tool has an air-cooled 2-cycle motor using unleaded gasoline and high quality synthetic oil with fuel stabilizer
specific for air-cooled 2-cycle motor.
• The motor is certified to run with unleaded gasoline with a minimum octane index of 87 (R+M) or higher.
• Gasoline and oil mix for motorcycles sold in service stations shall not be used.
• Engine oil for automotive or two-cycle oil outboard motors SHALL NOT be used.
• To prevent possible damage to the motor fuel lines and other parts in the motor use only gasoline with no ethanol or
alcohol (types of alcohol).
• Mix ratio is 32 parts gasoline and 1 part oil (32:1 ratio). Mix in an approved gasoline container. Mix thoroughly before
filling up the motor.
Do not mix gasoline and oil directly into the motor fuel tank.
CAUTION
Do not use fuel mix stored longer than 7 days. Mix only small quantities.
CAUTION
Do not smoke near the fuel or the filling up area where the fuel-oil mix is prepared or the tool is being
WARNING
operated.
Trying to start the tool without adding oil to the fuel mix causes motor failure.
WARNING
Using the ACT-2T-4 or ACT-2T-16
per each liter gasoline.
1
L
1 liter
Gasoline
To extend the working life of the motor use
When using the included bottle, the mix should be done taking as a reference the side indicated
CAUTION
as 30:1
Code
Motor
Speed
20 minutes rest per each fuel tank consumed.
A wrong mix may cause the motor to throw a rod causing
expensive repairs!
+
6 capfuls oil
COS-26X
12251
Hedge trimmer
12 lb
26 cc
9600 RPM
23.6 oz
Double
25.5"
87 dB
Maximum 6 daily hours.
OILS ** cap as measure, mix 6 capfuls oil
=
32:1
two-cycle synthetic motor oil.
* 1 gallon = 3,78 liters
ratio
Mix
** Not included
3
ENGLISH