Descargar Imprimir esta página

GE Quick Set V Manual Del Propietário página 16

Ocultar thumbs Ver también para Quick Set V:

Publicidad

Idiomas disponibles

Idiomas disponibles

Using the oven.
To ovoid possible burns, place the racks in the desired position before blOUturn on the oven.
The numberof rankpositionsmay vary
by model.
Before gou begin...
The racks have stops, so that when placed
correc% on the supports, theu will stop
before coming completelu out and will
not tilt.
When placing and removing cookware,
pull the rack out until it stops.
On some models, the bake heating element
is under the oven floor. Do not place foods
on the oven bottom for cooking.
To remove a reck, pull it toward Uou,
tilt the front end up and pull it out.
To replace, place the end of the rack
(stop-locks)on the support, tilt up the front
and push the rack in.
I-4,CAUTION I
When you ors using a rack in the lowest
position (A),you will need to use caution
when pulling the rock out. We recommend
that you pull the rock out several inches and
then, using two pot holders, pull the rock
out by holding the sides of it. Therock is low
and you could be burned if Fou place your
hand in the middle of the rock and pull oil
the way out. Be very careful not to bum
your hand on the door when using the rock
in the lowest position IA).
Aluminum
Foil
Do not use aluminum foil on the bottom
of the oven.
Never entirely cover a rack with aluminum
foil. This will disturb the heat circulation
and result in poor baking.
A smaller sheet of foil may be used to
catch a spillover by placing it on a lower
rack several inches below the food.
16

Publicidad

loading

Este manual también es adecuado para:

Quick set viNext step control