GE Quick Set V Manual Del Propietário página 40

Care and cleaning of the range.
I I SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect
_4, WARNING I the electrical power tothe range atthe main f use o rcircuit breaker panel
Failure to do so may result in electric shock or burn.
CAUTION
Receutacle Socket
_G&35 Bulb
I
Glasscover
(on some models)
I BURN HAZARD: The glass cover and bulb should be removed when cool. Touching hot glass with bare hands or a damp cloth can cause burns.
Oven Light Replacement (on some models)
Toremove-
I-7] Turn the glass cover counterclockwise
1/4 turn until the tabs of the glass
cover clear the grooves of the socket.
Wearing latex gloves may offer
a better grip. Receptacle
[] Using gloves or a dry cloth, remove
the bulb by pulling it straight out.
To replace:
[] Use a new 120/130-volt halogen bulb,
orcloth
not to exceed 50 watts. Replacethe Use gt0ves
bulb with the same type of bulb that y
was removed. Your model will have
one of the two types shown on
the left. To determine the correct
replacement bulb, check the bulb
terminals. Bulbswith 2 straight pin
terminals are G6.35bulbs. Bulbs
with 2 looped terminals are G9 bulbs.
(Do not interchange.)Be sure the
replacement bulb is rated 120 volts
or 130 volts (NOT12 volts).
@
[]
Using gloves or a dry cloth, remove
the bulb from its packaging. Do not
touch the bulb with bare fingers. Oil
from skin will damage the bulb and
shorten its life.
Pushthe bulb straight into the
receptacle all the way.
Placethe tabs of the glass cover into
the grooves of the socket. Turn the
glass cover clockwise 1/4 turn.
For improved lighting inside the oven,
clean the glass cover frequently using
a wet cloth. This should be done when
the oven is completely cool.
I-_ Reconnect electrical power to
the oven.
Glasscover
(onsomemodets)
_ii_ i]_ _ii_i_ii _
Wire cover holder
Oven Light Replacement (on some models)
Be sure to let the light cover and bulb cool
completely.
To remove the cover:
Toreplace the cover:
%
Hold a hand under the cover so
it doesn't fall when released.With
fingers of the same hand, firmly push
back the wire cover holder.Lift off the
cover.
Do not remove ang screws to remove
the cover,
%
Place it into groove of the light
receptacle. Pullwire forward to the
center of the cover until it snaps into
place.
I-_ Connect electrical power to the range.
40
I_] Replacebulb with a 40-watt
appliance bulb.