Dreame VTE1 Manual Del Usuario página 9

Product Overview
Introduction o Display Screen
Note: I the vacuum is not working properly, the screen display will produce an error
message. Please reer to the troubleshooting section to nd your solution.
Setting Language
Press and hold the button
to scroll through the language to select the desired one. Press and hold the button
or 3 seconds to use the selected language.
Note: The display screen will return the main page i there is no operation or more than 15
seconds.
Switching Suction Level
Press the button
The corresponding suction level will be highlighted on the display screen.
Auto Mode will be activated and "Auto" will appear on the display screen only when using
the smart multi-brush bar. The vacuum will then automatically switch the suction level
between the oor/tile and the carpet.
Note:
• Stop the vacuum at any time while cleaning. Then it will continue to use the last selected
suction level when started again.
• Connecting the smart multi-brush bar to the vacuum will activate the Auto Mode. In this
mode, the vacuum can automatically adjust its suction level depending on the surace
type.
or 3 seconds to open the language list, then press the button
to switch between three suction levels o eco, med/auto, and turbo.
Electronic Lock/Reset Filter
• Press briey to enter/exit lock
• Press and hold or 1.5 seconds to
enter the lter reset interace
Lock Status
Suction Level Status
Switching Suction Level
• Press briey to switch the suction
levels
5