Clock And Timers - Panasonic SC-UA3 Manual Del Propietário

Ocultar thumbs Ver también para SC-UA3:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

UA3PP_TQBJ2018_en.fm Page 10 Monday, May 15, 2017 9:58 AM
Selecting a preset station
1
Press [PLAY MENU] repeatedly to select
"TUNE MODE".
2
Press [R, T] to select "PRESET" and then press
[OK].
3
Press [2/3] or [5/6] to select the preset
station.
Using the unit
1
Press [8] to select "PRESET".
2
Press [2/3] or [5/6] to select the preset
station.
Improving the sound quality
1
Press [PLAY MENU] repeatedly to select
"FM MODE".
2
Press [R, T] to select "MONO" and then press
[OK].
To cancel, select "STEREO".
"MONO" is also canceled when you change the
frequency.
To memorize the setting
Continue with step 4 of "Manual presetting".
(Z page 9)
Checking the signal status
Press [DISPLAY].
FM – – – –
The FM signal is weak.
The system is not tuned in to a station.
FM ST
The FM signal is in stereo.
FM MONO
"MONO" is selected as the "FM MODE".
The FM signal is in monaural.
FM allocation setting
By unit only
This system can also receive FM broadcasts allocated in
0.1 MHz steps.
1
Press [RADIO/EXT-IN] to select "FM".
2
Press and hold [RADIO/EXT-IN].
After a few seconds, the display panel shows the current
minimum radio frequency. Release the button when the
minimum frequency changes.
• To go back to the initial setting, do the above steps
again.
• Preset frequencies are erased after you change the
setting.
10
10
digital printing

Clock and timers

Setting the clock
This is a 12-hour clock.
1
Press [SETUP] repeatedly to select "CLOCK".
2
Press [R, T] to set the time and then press [OK].
To check the time
Press [SETUP] repeatedly to select "CLOCK" and
then press [OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.
Play timer
(Except for Bluetooth
, AUX and D-IN source)
®
You can set the timer to come on at a certain time to
wake you up.
Preparation
Set the clock.
1
Press [SETUP] repeatedly to select "TIMER ADJ".
2
Press [R, T] to set the start time and then press
[OK].
3
Do step 2 again to set the end time.
4
Press [R, T] to select the source you want to play
and then press [OK].
To start the timer
1
Prepare the source you want to listen to (disc,
USB or radio) and set the volume.
2
Press [SETUP] repeatedly to select "TIMER SET".
3
Press [R, T] to select "PLAY ON" and then press
[OK].
"#" is shown.
To cancel, select "PLAY OFF".
The system must be turned off for the timer to
operate.
To check the setting
Press [SETUP] repeatedly to select "TIMER ADJ" and
then press [OK].
In standby mode, press [DISPLAY] two times.
Note:
The timer starts at a low volume and increases gradually to
the preset level.
The timer comes on at the set time every day if the timer is
on.
If you turn off the system and then turn on again while a
timer is in operation, the timer will not stop at the end time.

Hide quick links:

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido