Preparing The Media; Disconnecting A Device - Panasonic SC-UA3 Manual Del Propietário

UA3PP_TQBJ2018_en.fm Page 7 Monday, May 15, 2017 9:58 AM

Preparing the media

Disc
1
Press [CD x] (unit: [x]) to open the disc tray.
Put in a disc with the label facing up.
Press again to close the disc tray.
2
Press [USB/CD] repeatedly to select "CD".
USB
Preparation
Before you connect a USB device to the system, make
sure you do a backup of the data.
1
Decrease the volume and connect the USB device
to the USB port.
2
Press [USB/CD] repeatedly to select "USB".
Note:
•
Do not use a USB extension cable. The system cannot
recognize USB device connected through a cable.
•
Always disconnect the USB device before moving or tilting
the unit, e.g. when connecting external devices or
microphones.
• Some devices cannot be charged as the maximum USB
charging current is 500 mA only.
Bluetooth ®
You can connect and play an audio device wirelessly
through Bluetooth .
®
Preparation
• Turn on the Bluetooth feature of the device and put
®
the device near the system.
• Read the operating instructions of the device for
details.
█
Pairing a device
Preparation
If this system is connected to a Bluetooth
disconnect it (Z right).
1
Press [ ].
If "PAIRING" is shown, continue with step 3.
2
Press [PLAY MENU] to select "PAIRING" and then
press [OK].
3
Select "SC-UA3" from the Bluetooth
device.
If prompted for a passkey, input "0000" or "1234".
The device connects with this system automatically
after pairing is complete.
The name of the connected device is shown for a few
seconds.
Using the unit
1
Press and hold [
2
Select "SC-UA3" from the Bluetooth
device.
Note:
You can pair up to 8 devices with this system. If a 9th device
is paired, the device that has not been used for the longest
time will be replaced.
█
Connecting a device
Preparation
If this system is connected to a Bluetooth
disconnect it (Z below).
1
Press [
"BLUETOOTH READY" is shown.
2
Select "SC-UA3" from the Bluetooth
device.
The name of the connected device is shown for a few
seconds.
3
Start playback on the device.
Note:
•
A device must be paired to connect.
•
This system can only connect to one device at a time.
• When "BLUETOOTH" is selected as the source, this
system will automatically try to connect to the last
connected device. ("LINKING" is shown during this
process.)
█

Disconnecting a device

While a Bluetooth
1
Press [PLAY MENU] repeatedly to select
"DISCONNECT?".
2
Press [R, T] to select "OK? YES" and then press
[OK].
"BLUETOOTH READY" is shown.
To cancel, select "OK? NO".
Using the unit
Press and hold [
® device,
Note:
A device is disconnected when you:
•
Select a different source.
•
Move the device out of the maximum range.
•
Disable the Bluetooth
•
Turn off the system or the device.
® menu of the
digital printing
] until "PAIRING" is shown.
® menu of the
® device,
].
® menu of the
® device is connected
] until "PAIRING" is shown.
® transmission of the device.
7
7