Dreame D9 Manual Del Usuario página 9

Routine Maintenance
EN
Clean the Mopping Module
1. Press the two release clips on the side o water tank, remove the mopping
module and pull the mop pad o the mopping module.
2. Pour out the water in the tank. Clean with water only and leave to air dry
beore re-installing.
Note: Do not use any cleaning agents or disinectants.
14
3. Clean the mop pad with water only and leave to air dry beore re-installing.
Note:
•
Remove the pad rom the mopping module beore cleaning it, and make sure dirty
water does not low back into the water outlet to avoid clogging.
• For optimal perormance, it is recommended to replace the mop pad every 3 to 6
mouths.
4. I slow water low occurs, or the volume is not well-distributed, please
clean the air hole in the cover o the water tank.
Routine Maintenance
Clean the Main Brush
Press the brush guard clips inwards to remove the brush guard and lit the
brush out o the robot.
Pull out the brush covers as indicated by the diagram. Use the included
cleaning tool to remove any hairs tangled on the brush.
Clean the Side Brush
Pull out the side brushes and use the included cleaning tool to remove any hair
tangled on the brush.
Note: Do not pull out the hair excessively to avoid the damage o brush when the hair is
tightly tangled on the brush.
Clean the Main Wheel / Omnidirectional Wheel
Note: Use tools such as a small screwdriver, etc. to separate the axle and the tire.
EN
15