Skymsen PS-22 Manual De Instrucciones página 6

PROBLEMS
-The unit will not turn on.
-Burning odor and/or smoke.
-Alloy equipment but when
the product is placed on the
equipment, the same for or
revolves low rotation.
-Electric Cable damaged.
-Strange noises.
-The processed product comes out
crushed.
-The nut screw to during
operation
* Oil leak in the gearbox.
6
TABLE 02
CAUSES
-Lack of electrical energy;
-Worn or broken Gears;
-Problem in the internal or external
electrical circuit of the equipment.
-Problem in the internal or external
electrical circuit of the equipment.
-Worn or broken Gears;
-Problems with the Electric Motor.
-Transport of the product failure.
-Defective Bearings
-One of the components of the
mouth or incorrect mounting of the
same;
-Disks or Crosses blunt.
-Lack of electrical power on the
equipment;
-Problem in the internal or external
electrical circuit of the equipment;
-Worn or broken Gears.
- Sealing System of the damaged
equipment.
SOLUTIONS
-Check if there is Power;
Call authorized technical
assistance (ATA);
Call authorized technical
assistance (ATA);
Call authorized technical
assistance (ATA);
Call authorized technical
assistance (ATA);
Call authorized technical
assistance (ATA);
Call authorized technical
assistance (ATA);
Call authorized technical
assistance (ATA);
-Check the mounting sequence
according to (fig. 03);
-See item 5.2.1 of this manual.
-Check that the plug is plugged
into the socket, and if there is
power to the electrical network;
* Call authorized technical
assistance (ATA).
* Call authorized technical
assistance (ATA).