Lincoln Electric SAF-FRO DIGISTEP 355S Manual De Instrucciones página 7

Typical gas usage for MIG/MAG equipment:
Wire
Material type diameter
[mm]
Carbon, low
0,9 ÷ 1,1
alloy steel
Aluminium 0,8 ÷ 1,6
Austenic
0,8 ÷ 1,6
stainless steel
Copper alloy 0,9 ÷ 1,6
Magnesium 1,6 ÷ 2,4
Tig Process:
In TIG welding process, gas usage depends on cross-sectional area of the nozzle. For commonly used torches:
Helium: 14-24 l/min
Argon: 7-16 l/min
Notice: Excessive flow rates causes turbulence in the gas stream which may aspirate atmospheric contamination into
the welding pool.
Notice: A cross wind or draft moving can disrupt the shielding gas coverage, in the interest of saving of protective gas
use screen to block air flow.
End of life
At end of life of product, it has to be disposal for recycling in accordance with Directive 2012/19/EU (WEEE), information
about the dismantling of product and Critical Raw Material (CRM) present in the product, can be found at
https://www.lincolnelectric.com/en-gb/support/Pages/operator-manuals-eu.aspx
English
DC electrode positive
Current Voltage
[A] [V]
95 ÷ 200 18 ÷ 22
90 ÷ 240 18 ÷ 26
85 ÷ 300 21 ÷ 28
175 ÷ 385 23 ÷ 26
70 ÷ 335 16 ÷ 26
Wire Feeding
Shielding Gas
[m/min]
3,5 – 6,5 Ar 75%, CO
5,5 – 9,5
Ar 98%, O
3 - 7
He 90%, Ar 7,5% CO
6 - 11
4 - 15
3
Gas flow
[l/min]
25% 12
2
Argon 14 ÷ 19
2% /
2
14 ÷ 16
2,5%
2
Argon 12 ÷ 16
Argon 24 ÷ 28
English