Protemp PT-80V-LPC-A Manual De Instrucciones página 9

EXTREMELY HOT during operation. Do Not touch any metal components while in
WARNING
operation. Keep gasoline and any other flammable liquids away from the heater.
Lighting Instructions:
PT-80V-LPC-A
1. STOP! Read all of the safety information
provided with this heater.
2. Turn valve on propane cylinder
COUNTERCLOCKWISE until fully open.
3. Press in control knob and turn
COUNTERCLOCKWISE to LOW/IGN position.
4. If burner does not ignite, turn control knob to
OFF position and repeat the ignition procedure.
5. Keep control knob pressed in for approximately
30 seconds before releasing.
6. If the flame goes out, wait 5 minutes and
repeat the ignition and lighting steps.
7. After heater ignites, turn the control knob to
desired heat setting.
Relighting Instructions
1. Rotate valve on cylinder CLOCKWISE to close
it and wait 5 minutes.
2. Relight following the Lighting Instructions,
steps 1-7.
Shut Down Instructions
1. Turn control knob to the OFF position.
2. Rotate valve cylinder CLOCKWISE to close it.
© 2015, Pinnacle Products International, Inc.
All manuals and user guides at all-guides.com
NEVER LEAVE HEATER UNATTENDED WHILE BURNING,
CONNECTED TO A POWER SOURCE, OR WHILE
®
CONNECTED TO A FUEL SOURCE
Operation
PT-200V-LPC-A
1. STOP! Read all of the safety information
provided with this heater.
2. Turn valve on propane cylinder
COUNTERCLOCKWISE until fully open.
3. Set control valve to LIGHT/LOW position,
then wait 15 seconds before step 4.
4. Depress the red button on the safety valve,
admitting gas to the burner. While pressing
the safety valve, push and release the ignition
button until the burner lights.
5. When the burner lights, continue to keep the
red safety valve depressed for 30 seconds
then release.
6. If burner goes out, wait 5 minutes and repeat
lighting procedure.
7. When burner lights, you can now adjust the
heat setting to HIGH by sliding the control
valve up to the HIGH setting.
NOTE: When adjusting heat setting, the control
valve only needs to slightly slide up to achieve
HIGH setting.
Relighting Instructions
1. Rotate valve on cylinder CLOCKWISE to close
it and wait 5 minutes.
2. Relight following the Lighting Instructions,
steps 1-7.
Shut Down Instructions
1. Rotate valve cylinder CLOCKWISE to close it.
8 Convection Heater User's Manual