Bosch GSB18V-1330C Instrucciones De Funcionamiento Y Seguridad página 13

GCY42 Connectivity module installation
(sold separately)
To reduce the risk of injury
r e a d
instructions included with Bosch GCY42
connectivity module. Operating instructions for
GCY42 connectivity module include important
information not covered in this manual.
Only use Button/coin cell 3V
lithium CR2032 battery. Do
not use any other button/coin cells or other forms of
electrical power supply.
E n s u r e
replacement is carried out
properly. There is a risk of explosion.
Chemical Burn Hazard. Keep
batteries away from children.
This product contains a lithium button/coin cell battery.
If a new or used lithium button/coin cell battery is
swallowed or enters the body, it can cause severe
internal burns and can lead to death in as little as 2
hours. If you think a battery might have been swallowed
or placed inside any part of the body, seek immediate
medical attention.
Always completely secure the
c o n n e c t i v i t y
compartment. If the connectivity module compartment
does not close securely, stop using the product, remove
the battery, and keep it away from children.
When discarding batteries,
insulate the '+' and '–'
terminals with insulating tape. When disposed of
improperly, lithium batteries may short, causing them to
become hot, burst or ignite.
Never dispose of the batteries
in a fire or expose to high
heat. The batteries may explode.
Assembly
t h e o p e r a t i n g
t h a t b a t t e r y
m o d u l e
13
FIG. 7
(10)
If GCY42 connectivity module is not purchased with the
tool, or if the replacement of the module or the battery
becomes necessary, please follow this procedure (see
Fig. 7):
- Using a flat screwdriver or a coin, remove the
cover (10) from the side of the handle, by turning
it 1/4 turn counter-clockwise.
- If the tool is already equipped with the
connectivity module, remove the battery a, but
do not remove the connectivity module b.
- If the connectivity module is installed for the first
time, remove the plastic placeholder c from the
connectivity module compartment, and place
the connectivity module b in the compartment
observing correct orientation.
Note: Store the placeholder c in a safe
place. Reinsert the placeholder again if the
communications module is removed.
- Next place new battery a on the top of the
connectivity module with the "+" polarity facing
up.
- Place the cover 10 over the battery and turn it
¼-turn clockwise to lock using a flat screwdriver
or a coin.
(10)
a
b
c