Publicidad
Idiomas disponibles
Idiomas disponibles
Note:
- Please power off the transceiver before replacing the fuse, the required fuse is DC 15A.
■ External GPS antenna (3-GPS Antenna interface):
Connect to an external GPS antenna. This interface is only available on models with GPS, and is not available on models without GPS.
Make sure that the GPS antenna is installed in an open and unobstructed position so that the satellite signal can be received well. When
installing the GPS antenna, use the supplied double-sided adhesive tape to fix it.
■ Ground terminal (4-Screw hole):
Connect this terminal to a vessel ground to prevent electrical shocks and interference from other equipment. Use a PH M3x6mm screw (not
supplied).
■ NMEA in/out cable:
Through the rear panel cable, this transceiver can connect GPS input signals from GPS receivers, and can also output GPS signals to other
devices.
● Connect a PC or navigation equipment (5-White cable):
Used to output position data received from other ships to a computer or navigation device.
Transceiver output signal conforms to NMEA0183 version 3.01 sentence formatters DSC, DSE compatible.
● Connect a GPS receiver (6-Red cable):
Used for ship position indication.
A NMEA0183 ver. 2.0 or 3.01 (sentence formatters RMC, GGA, GNS, GLL) compatible GPS receiver is required.
■ Cloning cable (7-Blue cable):
Connect a cloning cable.
English - 49 -
Publicidad
