Before a Hybrid cleaning cycle
Fig. 1
Don't hand
clean the
oven door
gasket.
You may
hand clean
the door.
Fig. 2
NOTE
Remove oven racks and accessories before starting the Hybrid clean mode.
NQ70M6650DS_AA_DE68-04446A-00_EN.indd 53
•
Remove the wire rack, broil pan, broil
pan insert, all cookware, and any
aluminum foil from the oven.
•
Wipe up debris from the oven bottom.
(Fig. 1)
•
The silver-colored oven racks can be
Hybrid Cleaned, but they will darken,
lose their luster, and become harder to
slide.
•
Residue on the front frame of the oven
and outside the gasket on the door
will need to be cleaned by hand. Clean
these areas with hot water, soap-filled
steel-wool pads, or cleansers such as
Soft Scrub. Rinse well with clean water
and dry.
•
Do not clean the gasket. The fiberglass
material of the oven door gasket cannot
withstand abrasion. It is essential for
the gasket to remain intact. If you
notice it becoming worn or frayed, have
it replaced. (Fig. 2)
•
Make sure the oven light cover is in
place and the oven light is off.
How to run a Hybrid cleaning cycle
Remove all accessories from the oven.
1.
2.
Open the oven door, and then touch Reservoir
reservoir. Grasp the front of the reservoir and pull it all the way out of the
slot.
3.
Pour approximately 20 oz. (600 ml) of water into the water reservoir. Use
normal water only, not distilled water.
NOTE
You can open the reservoir by removing the rubber cap or by removing the
clear plastic top.
4.
Replace the rubber cap or clear plastic top.
Return the reservoir to the slot, and then push it in. There will be slight click
5.
when it is in place correctly. Touch Reservoir
reservoir.
6.
Close the oven door.
7.
Touch Hybrid Clean. Touch Hybrid Clean once for a 20 min clean time, twice
for a 90 min clean time. (The default setting is 20 min.)
8.
Touch START/SET. The motor-driven door lock will engage automatically.
When the operation is complete, the display will blink and a beep will sound.
NOTE
Only the lower oven door is locked during Hybrid cleaning.
9.
Touch OVEN OFF.
10.
Clean the oven's interior. There will be a significant amount of water
remaining on the bottom of the oven after a Hybrid cleaning cycle. Remove
the residual water with a sponge or soft dry cloth.
NOTE
For Hybrid Cleaning, use exactly 20 oz. (600 ml). of water since this produces the
best results.
. The oven ejects the water
. The oven retracts the water
English 53
2017-01-05
6:16:13