Publicidad
Idiomas disponibles
Idiomas disponibles
NQ70M6650DS_AA_DE68-04446A-00_EN.indd 57
4.
Shake the graphite lubricant before
opening it. Starting with the left (front
and back) slide mechanism of the rack,
place four (4) small drops of lubricant
on the two (2) bottom tracks of the
slide close to the bearing carriers.
5.
Repeat for the right (front and back)
slide mechanism of the rack.
6.
Open and close the rack several times
to distribute the lubricant.
7.
Replace the cap on the lubricant and
shake it again. Turn the rack over and
repeat steps 3, 4, 5 and 6.
8.
Close the rack, turn the rack right-side-
up, and then place in the oven. See
installing the gliding rack in Using the
Gliding Rack on page 39.
NOTE
Do not spray the gliding rack with cooking
spray or other lubricant sprays.
Oven door
•
Don't hand
clean the
oven door
gasket.
You may
hand clean
the door.
•
Use soap and water to thoroughly
clean the top, sides, and front of the
oven door. Rinse well. You may use a
glass cleaner on the outside glass of
the oven door. DO NOT immerse the
door in water. DO NOT spray or allow
water or the glass cleaner to enter the
door vents. DO NOT use oven cleaners,
cleaning powders, or any harsh
abrasive cleaning materials on the
outside of the oven door.
DO NOT clean the oven door gasket.
The oven door gasket is made of a
woven material which is essential for a
good seal. Care should be taken not to
rub, damage, or remove this gasket.
English 57
2017-01-05
6:16:14
Publicidad
