Switching The Machine On/Off; Selecting The Speed Range - BDS Maschinen MAB 855 Instrucciones De Manejo

Switching the machine ON/OFF

Selecting the speed range

MAB 855
Using the ON/OFF switch (21), turn the machine ON with the
‹
green button (I) and OFF with the red button (O).
NOTE
► The machine can only be switched on when the magnetic
clamp has been switched on.
► Allow a severely overheated machine to run on at idle speed
for approx. 2 minutes to cool it down.
► The machine switches off automatically in the event of a
power failure or if the magnetic clamp is switched off.
CAUTION
► Switch the gear stages only with the machine at standstill.
The machine is equipped with a gearbox that has four mechanical
gear stages. The gear stage is set using both selector levers (5)
on the side of the gear box.
To select the desired gear stage, switch the machine off and
‹
set both selector levers (5) to the desired speed as shown in
the table below.
Gear stage Load speed
Stage 1
Stage 2
Stage 3
Stage 4
NOTE
► Select the speed range according to the material and drilling
diameter.
anti-clock-
wise
▼
110 rpm
▼
175 rpm
▲
245 rpm
▲
385 rpm
Operation
Selector lever
clockwise
▲
▼
▲
▼
49