Eliminating Blockages - BDS Maschinen MAB 855 Instrucciones De Manejo

Eliminating blockages

MAB 855
NOTE
Observe the following instructions when drilling with core drills:
► Drilling with core drills does not require great force. The drill-
ing process is not accelerated by higher pressure. The drill
wears faster and the machine can be overloaded.
► Use the high-performance BDS 5000 cutting oil in the cool-
ing lubricant system of the machine.
► The cooling lubricant system cannot be used when work-
ing overhead. In this case, use the high-performance ZHS
400 grease spray. Spray the drill on the inside and outside
before drilling. Repeat this procedure when drilling deeper
holes.
► Make sure that swarf is removed regularly. In the case larger
drilling depths, break swarf regularly.
WARNING
Danger of cut injuries from broken tool parts or swarf.
► Put protective gloves on before starting work.
Blockages caused by a broken tool:
Switch off the machine. Remove plug from the mains socket.
‹
Use the handle to move the machine slide to the upper posi-
‹
tion.
Replace defective tool. Remove swarf.
‹
Other blockages:
Switch the machine of using the motor switch. Leave the
‹
magnetic clamp switched on.
Use the handle to move the machine slide to the upper posi-
‹
tion.
Remove swarf and check tool.
‹
Eliminating blockages
51