Service; Specific Safety Rules - ENAR M35 AFP-M5 Manual De Instrucciones

CHECK for misalignment or binding of moving parts, breakage of parts, and any other condition that
may affect the tools operation. If damaged, have the tool serviced before using.
USE only accessories that are recommended by the manufacturer for your model.

3.3 SERVICE

Tool service MUST BE PERFORMED only by qualified repair personnel.
When servicing a tool, USE only identical replacement parts.
FOLLOW instructions in the Maintenance section of this manual.

3.4 SPECIFIC SAFETY RULES

For your own safety, as protection for others, and to avoid damage to the motor, read carefully the
following usage recommendations.
IN ADDITION, LOCAL COUNTRY ESTABLISHED ORDINANCES SHOULD BE RESPECTED.
ELECTRIC VIBRATING POKERS
1.- Firstly read the instruction of the converter where you are going to connect the
vibrating pokers.
2.- For the operation of the vibrating poker, make sure that operators have been
instructed in the proper usage of the machine.
3.- The vibrating poker should only be used in the specific jobs for which it has been
developed and under the instruction and safety recommendations of this manual.
4.- Be sure that the parts of the poker are tight before starting working.
5.- The vibrating poker plug should not be used to start or stop the equipment, use the
switch.
6.- Protect the electrical cable against heat, oil, or sharp edges.
7.- Avoid the flattening of the cable by heavy machinery which could cause breakage.
8.- Check the electrical cable is with the proper section and it is in good condition. (See
section 3.3.2 )
9.- Do not work close to flammable liquids or in areas exposed to flammable gases.
10.-The vibrating poker should not be working out of concrete more than 5 minutes.
Switch on before starting working and disconnecting them immediately after finishing the
vibrating operation.
11.- Avoid the vibrating pokers are working in contact with hard object during a long
period.
12.- Do not stop the vibrating poker inside the concrete.
13.- Do not permit untrained personnel to operate the vibrating poker or connections.
14.- Disconnect the vibrating poker from the converter before doing any operation.
15.- Change the external wear parts to avoid damage to the internal parts. (Table 1.3.2).
16.- Proper protective equipment SHOULD BE USED because the acoustic pressure of
this machine is 79dB and acoustic power level is 85dB.
17.- The vibration that transmits to the operator does not exceed 2,5 m/s 2 of
acceleration.
M35 AFP-M5 AFP-M6 AFP-M7 AFP-M8 AFP
MP35 AFP-MP5 AFP-MP6 AFP-MP7 AFP
en
5