Regular Maintenance - ENAR M35 AFP-M5 Manual De Instrucciones

4.4 REGULAR MAINTENANCE

1. Only an expert shall work on the electrical parts.
2. Disconnect the vibrating poker of the converter before doing any maintenance
3. In all maintenance operations, original parts will be used.
4. Every 12 months of working a lubrication of the bearings of the vibrating pokers is
recommended. An expert should dismantle the vibrating poker. Clean with solvent the bearings and
when this is dry fill with the specified grease the 30% to 40% of the clear space of the bearing. If you
note an excessive play in the bearings proceed to change it. When you remount place the "O" rings
and sealant in all the threads. Tighten and clean the excess of sealant. It is important all the parts
are tighten
apply two weld spots to secure the parts do not loose.
The recommended grease is ISOFLEX LDS 18 SPECIAL A of the trademark KLÜBER
LUBRICATION or other similar with the following characteristics:
5.
watertight.
6.
7.
done by an authorised dealer.
8.
the housing or cap when the diameter or length in the least point is less than the specified in the
table according to the model.
Modelo
M35 AFP
M5 AFP
M6 AFP
M7 AFP
M8 AFP
a.
b.
c.
d.
ELECTRIC VIBRATING POKERS
(600 to 800 Nm of torque) to avoid the water does not penetrate in the head. Finally,
Base........................................................................................Li-SE
Dropping point acc. to DIN 51801/1 (ºC) .................................>250 ºC
Temperature range (ºC) ..........................................................-50 a 120 ºC
Working penetration accc. to DIN 51 804 (0.1 mm) .................295
Consistence NLGI to DIN 51 818 ............................................2
Dynamic viscosity (mPa s) ......................................................4500
Speed factor (n dm).................................................................1000000
Always you change the switch be sure the bolts of the switch box are tighten and the box is
After maintenance jobs all the parts must be assembled correctly.
Every 12 month or more frequently, depending on the use, it is recommended an inspection be
Check the wear of the poker controlling the outside diameter and length of the poker. Replace
Diámetro(mm) Longitud (mm)
34,5 (36)
48 (50)
56 (58)
63 (65)
75 (73)
The minimum dimensions are bold printed
The dimensions into brackets are the original dimensions
Replace the housing when reach the minimum diameter
Replace the cap when reach the minimum length
M35 AFP-M5 AFP-M6 AFP-M7 AFP-M8 AFP
MP35 AFP-MP5 AFP-MP6 AFP-MP7 AFP
345 (350)
395 (400)
420 (430)
425 (430)
395 (400)
en
7