Publicidad
Idiomas disponibles
Idiomas disponibles
7.4 To Begin Pumping
STEP 1: INSERT TUBING
Insert Tubing adapter into the right side of the pump base, then turn the pump
slightly to the right, and gently push it to make sure it connects firmly.
A. For DOUBLE PUMPING: Both tubes should be attached to
the tubing adapter.
B. For SINGLE PUMPING: Remove one tube from the tubing
adapter and close one side using the attached plug.
STEP 2: PLACE THE FLANGE ON BREAST
Center flange on breast to create seal.
Check breast flange fit, if pumping causes discomfort a larger
or smaller breast flange size may be needed. See section on
how to properly fit your flange.
See section 7.5 below on how to properly fit your flange.
STEP 3: POWER ON THE PUMP
Press the Power button to turn on the device.
It will begin in Stimulation Mode.
ART-70295-01-AA
ENGLISH | 15
Publicidad
